2 8mm bearing on each end of the shaft...spinning smoothly.


8 mm shaft


neo`s r 40x20x10


as 1 can see ima gonna do a test with 2 rotors...differents is in the positon of tha neo`s.
the 1 that give me more speed or/and voltage is gonna be ma choice 2 work with.


just a preview of tha Window type...its almost done now...


i have boxed in tha Bedini Circuit with the 5v and 12 Voltage regulator...so it makes it easy for testing.
also add a input voltage/input amps and output amps...high DC output meters r not 4 sale...so ima gonna use a multi-meter here.
and some switches 2 turn off/on at will.
btw...those yellow spots where ma Big feet...no need 4 that on these Pics.


closer look at the new Window type...and yes ima still using tape...when i know wich 1 of tha magnetes setup works best i`ll make it better without tape.
about 110 turns there.


a look at the backside of tha Bedini(Pandora) Box where all the connection r....:))
it doesnt run atm...i think bad wire connection somewhere...u dont want 2 see in the Box...its a Jungle in there.


with the new rotor-setup ma magnetes will be far closer 2 each other...and ima gonna test 2 types of rotor aswell(again).


this is how ma Window type Bedini is atm...
system in tha box is now a Darlington pair...2x TIP3055...thnx 2 comwarrior69 :)


this is the Sequential Bipolar Circuit i`ve just finished...thnx 2 shannrenn :)
hope i made all the connection right...will notice that when ima use it tha first time
i made like this becoz if its oke ima gonna box it in also just like the above 1 and put switches and meters on it.


the darlington pair box system upclose...
and yeh the output voltage meter is only 30volts...when i do ma coil 500 turns Trifiliar i`ll use a multi-meter instead.


12pole and 10pole rotors... N/S alternating @ 180 degrees.


another look at the rotors...:)


this is the half Bipolar circuit from Ren...:)